Advertisement
SteP SIx: PrOgraMMIng tHe telePHOne nUMberS
We recommend using your cell phone as the first person on your list. Make sure you have
permission from each person on your list to use their phone number.
1. Enter the setup mode by pressing your password followed by the [PROG] button.
2. Press the [#/DOWN] button. "MEMORY" should be flashing. Press [ARM/DISARM]
to select.
3. "
" should be in the left corner. Key in the first phone number you want the unit to
1
call and press [ARM/DISARM] when you have finished keying it in. If you make a
mistake, press the [DEL/PAUSE] button to erase incorrect numbers. If you need to add a
pause in between numbers, press the [DEL/PAUSE] button.
4. Press the [*/UP] button to advance to the second phone number. "
ing in the left corner. Key in the second number you want the unit to call and press the
[ARM/DISARM] button when you have finished. You may program up to 5 numbers.
Once you program in a phone number, you will need to press the [DEL/PAUSE] button
to delete the existing number if you need to change it.
SteP Seven: teSt tHe WIreleSS SeCUrIty SySteM
A. Let the first person on your list know that you are about to test the system.
B. Press the [Arm] button on the Remote Control. Wait for a minute. At that time the
Control Unit will beep. Now trigger one of the sensors. The Control Unit will beep an
alarm sound and then call the first number on your list. Have the person on the other
end press 2 on the phone and then the password. Then press 2 to disarm.
SteP eIgHt : PerManently MOUnt tHe COMPOnentS
1. Mount the control unit to the wall, or place on a
sturdy table. For wall mount, drill holes and install
anchors and screws. Place the unit over the screws and
slide it down to a secure place. (Fig. 1)
" should be show-
2
Page 4
2. Mount the magnetic door/window sensor. Choose a suitable loca-
tion, drill holes, and install anchors and screws. Place the unit over the
screws and slide it down to secure in place. (Fig.2)
3. Mount the magnetic wired piece to the door or window frame and the
matching non-wired piece to the other side by using the double-sided
tape (included). (Fig.3) Make sure that the arrow on the wired sensor
points to the non-wired sensor. The two sensors should be no more
than ¼" apart. (Fig.4)
4. Permanently mount the wireless motion detector sensor. Drill holes and install anchors
and fix the bracket by screws. Place the main unit into the bracket and slide it down to se-
cure in place. (Fig 2) You can adjust the bracket to obtain the best coverage of the intended
protected area. (Fig 3)
Page 5
Hide quick links:
Advertisement
