Tank Filling And Water Treatment - First Degree Fitness Apollo AR Owner's Manual

Tank Filling and Water Treatment:

Siphon
1. Remove Rubber Fill Plug from the top of the tank.
2. Place a large bucket of water next to the rower and position siphon with the rigid hose in the
bucket and the flexible hose into the tank as shown. Note: Make sure small breather valve
on the top of the siphon is closed before filling.
Note: Where water quality is known to be poor, FDF recommends the use of distilled
water.
3. Begin filling tank by squeezing siphon. Use Level Gauge Decal on side of tank to measure
volume of water in tank. Important: Do not overfill tank!
4. After filling tank to the desired water level, open the valve on the top of the siphon to allow
excess water to escape.
5. Ensure that tank plug is replaced once filling and water treatment procedures are complete.
Tips on Siphon use: Putting the fill bucket higher than the tank will allow the siphon to "self-
pump" when adding water to the tank.
Water Treatment Procedures:
Add Chlorine tablet.

Note: The amount of water treatment can vary widely depending on the Rower's lo-
cation and exposure to sunlight. DO NOT, UNDER ANY CIRCUMSTANCES USE
OTHER TREATMENT TABLETS OTHER THAN THOSE SUPPLIED WITH YOUR
ROWER. Your rower box contents include 4x water treatment tablets, which is suffi-
cient for several years of water treatment. Treat when water becomes discolored or
shows signs of Algae/Bacterial growth. To purchase additional chlorine tabs,
please consult your nearest regional dealer/distributor or check our website at
www.firstdegreefitness.com
Caution:
10
Tank plug
Use a drop cloth under the tank when filling or emptying the
tank to avoid staining floor or carpet
Note: 17 liters of water are required for filling.
DO NOT USE ANYTHING OTHER THAN
PURE WATER TO FILL YOUR FLUID TANK.
Fill tank
with
adjuster
handle set
to "MAX"
only.