First Degree Fitness Apollo AR Owner's Manual page 7

Completing The Apollo Hybrid AR Assembly:
Tighten frame
bolts securely
once rower is
standing.
7
Pull Bungee Cord and hook Bungee end
onto the Bungee hook mount as shown.
Once the Bungee cord is attached to the Rear
Brace, tighten the bolts holding the Footboard, the
Mainframe to Side rail bolts as they are easier to
access from the vertical position.
Lower the Apollo Hybrid AR back to the Horizontal
position and test for proper bungee recoil.
Check Seat rollers/running boards for dirt or debris
before sitting on the rower seat. Small objects cap-
tured between the seat rollers and runners can
damage the wheels or running surface. Check run-
ners for debris prior to each use and clean
regularly.
Note: The Apollo Hybrid AR frame bolts require
periodic checking for tightness. Do this at the end
of the first month of use and again after every 12
months
Choose a suitable location when standing the
product for storage.
The Apollo Hybrid AR frame can be polished with
any high grade furniture polish to further highlight
the rich luster of the wood finish.
Install supplied 2x AA Duracell batteries and check
computer function. Details regarding can be found
in the Computer section of this manual.
Choose a flat, level surface on which to use your
Viking Rower, to avoid rocking and potential prem-
ature wear.
Cut Bungee tie wrap ONLY
after Bungee hook is
properly connected to Rear
Brace.
Do not cut
Bungee tie wrap
before Bungee
cord is attached
to rear of rower
as shown here.