First Degree Fitness Apollo AR Owner's Manual page 5

Side Rail/Rear Brace/Transport Wheel assembly:
Start with the Rear Brace and on the underside you will find a pre-installed bolt. From the hardware kit,
take the Bungee hook mount and install it onto the Rear Brace as shown. Note the orientation of the
Brace and hook must be correct in order to hold the end of the bungee shock cord as depicted by the
arrow in the illustration, which points toward the front of rower.
Next, connect the Side Rail Left and Side Rail Right using 4x
M6x15mm bolts and Rear Brace. Do not tighten.
Side Rail Assembly
Transport wheel
assembly
Transport wheel assembly
Washer
Nylock Nut
5
Side Rail Right
Side Rail Left
M6 x 15mm bolts
Transport wheel axle
Transport wheel
Side Rail
Right
Bumpstop
Once the Rear Brace and Side Rails
are assembled, mount the Transport
wheel assembly onto the Left/Right
Side Rails.
Note: One washer on outside and one
washer on the inside of the side rail.
Do not over tighten the Transport
wheel axle as it may inhibit Transport
Note transport wheels
wheel rotation.
must be mounted on
the outside of Side
Rails as pictured
Tip: Bumpstops facing inside of rail
above.
for correct assembly orientation.
Rotate Rear Brace to correct orientation
before assembly onto Side Rails
Pre-installed bolt
Rear Brace
(Underside)
Bungee
Hook mount
M6 x 15mm bolts
Rear Brace
Towards Front
of Rower