5. Using a sharp hobby knife, cut the covering and balsa
sheeting from the inside of the aileron servo tray area. Trim
only the covering from the outer aileron servo tray area.
6. Use CA to glue the aileron servo tray to the top of the
wing centered over the servo opening.
ASSEMBLE THE FUSELAGE
Mount the Wing
1. Trim the covering from the two bolt holes at the trailing
edge of the wing.
2. Test fit the wing to the fuselage and bolt it into position
with two 3x30mm machine screws and 3mm washers.
Mount the Stabilizer and Fin
1. Using a sharp hobby knife, remove the covering from
the stabilizer slot at the aft end of the fuselage. Also remove
the temporary balsa block.
2. Mark the center of the trailing edge of the stabilizer.
Insert the stabilizer into the slot.
3. Stick a T-pin into the center of the top of the firewall.
Tie a small loop in one end of a 36" [910mm] piece of non-
elastic string such as K&S #801 Kevlar thread. Slip the loop
in the string over the T-pin.
9