Mount The Cowl And Prop - GREAT PLANES Super Sportster EP ARF Instruction Manual

9. Install a two-arm servo arm with holes 7/16" [11mm]
from the center of the arm.
10. Thread the two nylon torque rod horns onto the
aileron torque rods. The bottom of the horn should be
approximately 1/4" [6mm] from the wing.
11. Thread a nylon clevis 14 turns onto the end of the two
2-56 x 4" [100mm] aileron pushrods. Attach the clevises to the
torque rod horns. Slide a silicone clevis keeper on each clevis.
12. With the aileron servo and ailerons centered, mark
the aileron pushrods where they cross the aileron servo
arm. Make a 90° bend at the marks and cut the pushrods
3/8" [10mm] past the bend. Attach the pushrods to the
aileron servo arm with nylon snap keepers. Cut off the
excess threads on the aileron torque rods.

MOUNT THE COWL AND PROP

1. Slide the cowl over the front of the fuselage.
2. Slide the prop shaft and collet onto the output shaft of
the gear drive. The collet has a tapered hole through it. The
side with the larger hole goes on first.
3. Install the spinner backplate, prop, prop washer and
prop nut on the prop shaft. The back of the prop has two
indentations in the hub.
4. In the side of the collet is a small hole. Insert the provided
wire in the hole and tighten the prop nut. Make sure that the
prop is centered between the two spinner nose cone guides.
15