Elba EGH-B9230G Owner's Manual page 11

CONNECTION TO THE GAS SUPPLY
The gas Connection must be made in accordance with
the local standards. When
the end of the pipeline. The appliance leaves the
factory tested and set for the type of gas indicated on
the plate inside the bottom guard, close to the gas
connection pipe. Make sure that the type of gas to be
supplied to the appliance is the same as that shown
on the plate. Otherwise, follow the instructions
provided in the "Adapting to different types of gas"
section.
For maximum efficiency and minimum consumption,
make sure that the gas supply pressure complies with
the values shown in the gas used is different from that
specified (or variable).a suitable pressure regulator
must be installed on the supply pipeline.
The union must be fitted on the end of the gas train. Complete with GJ1/2＂
threaded nut, fitting the gasket between the components as shown in the
illustration. The gaskets must comply with the local standards. Screw the parts
together without forcing, fit the union so that it points in the direction required
then tighten all parts.
CONNECTION
Make the connection to the gas system using a rigid metal pipe and regulation
unions, or with a stainless steel hose complying with the local standard. If
metal hoses are used, take care that they do not come into contact with mobile
parts and are not crushed. This must also be checked if the hob is to be
combined with an oven.
The gas intake connection of the appliance has a " male thread."
When making the connection, take care not to apply stresses of any kind to
the appliance.
When the installation is complete, always check that all the unions are
absolutely tight using a soapy solution. Never use a flame to make
this check.
installing, fit a safety tap at
10