Oven Door - GE 600 Series Owner's Manual

Hide thumbs Also See for 600 Series:
Table of Contents

Advertisement

Available languages

Available languages

Oven Door

The door is very heavy. Be careful when removing and lifting the door. Do not lift the door by the handle.
To Clean the Door Exterior and Interior
and front of the oven door. Rinse well. You may also use
a glass cleaner to clean the glass on the outside of the
door. Do not let water drip into the vent openings, holes,
or slots in the door.
• If a stain on the door vent trim is persistent, use a
mild abrasive cleaner and a sponge-scrubber for best
results. Do not use this method on any other surface.
• Spillage of marinades, fruit juices, tomato sauces
and basting materials containing acids may cause
discoloration and should be wiped up as soon as
safely possible. When the surface is cool, clean and
rinse.
• Do not use oven cleaners, cleaning powders or harsh
abrasives on the outside of the door.
To remove the door:
NOTE: Door removal is not a requirement for installation
of the product but is an added convenience.
1. Fully open the door.
2. Pull the hinge locks down
toward the door frame, to
the unlocked position. A
tool, such as a small flat-
blade screwdriver, may
be required.
3. Firmly grasp both sides of
the door at the top.
28
Slot
Hinge lock
Pull hinge locks down to unlock
4. Close door to the door removal position. The
door should be open
approximately 3" with no
obstruction above the door.
5. Lift door up and out until
both hinge arms are clear
of the slots in the range
frame.
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. With the door at the same
angle as the removal position,
rest the notch in the bottom
of the left hinge arm on the
bottom edge of the left hinge
slot. The notch in the hinge
arm must be fully seated onto
the bottom of the slot. Repeat
for the right side.
3. Fully open the door. If the door will not fully open,
the notches in the bottoms of the hinge arms are not
seated correctly onto the bottom edge of the slot. Lift
the door off the range and repeat the previous step.
4. Push the hinge locks down to
the locked position.
5. Close the oven door.
Removal position
Hinge arm
Bottom
edge of
slot
Notch
Hinge
arm
Hinge
lock
Push hinge locks
down to lock
49-2001193 Rev. 0

Advertisement

Chapters

Table of Contents
loading

Table of Contents