Azimuth-Setting - Clearaudio Peerformance Instruction Manual

The middle groove is used for the exact speed. The upper groove increases the
speed a little bit, the lower groove reduces the speed a little.
Important:
Turn the platter now by hand, to ensure the perfect positioning of the belt around the
platter.
33 1/3 ++
33 1/3
33 1/3 --

5 Azimuth-setting

Please note that the azimuth is pre-set exactly. If for any reason the azimuth must be altered
to compensate the geometry of some pick-up/cartridges, follow these steps:
loosen the screw on the bottom side of the tone arm near the headshell. Now you can adjust
the azimuth by turning the headshell gently in the tonearm. When finished, lock the screw
again.
Page 16
Performance
© clearaudio electronic GmbH 2007
Instruction manual
45 ++
45
45 --