Clearaudio Peerformance Instruction Manual page 15

Performance
Instruction manual
Turning the counter weight forward or backward (green arrow = more tracking
force/backward = less tracking force) you can now set the exact weight of the pick-up
/cartridge.
Now mount the pulley on the motor-unit. Slide the pulley onto the axle. Make sure the
distance between the bottom of the pulley and the motor-chassis is about 3 mm. Tighten the
pre-mounted screws with the enclosed screwdriver.
3 x
ca. 8 mm
Place the motor into the cut out on
the left of chassis. Put the belt
around the platter and the pulley. The pulley is
equipped with 6 little grooves fort the belt. Those with
a smaller diameter are used for the speed 33 1/3 U/m,
those with the bigger diameter are used
for the speed 45 U/m.
Page 15 © clearaudio electronic GmbH 2007