Oki OKIPAGE 10e Service Manual page 197
Digital led printer
Hide thumbs
Also See for OKIPAGE 10e:
- Maintenance manual (308 pages) ,
- User manual (46 pages) ,
- Setup manual (20 pages)
Table of Contents
Advertisement
1.2 Engine Menu Setting Group
This area shows the engine menu, the settings of which can be changed. The details of each item are as follows.
<Print Position>
Shown message
Setting item
Setting range
F/W default
<LED Head Drive Time>
Shown message
Setting item
Setting range
F/W default
<HEAD TYPE>
Shown message
Setting item
Setting range
F/W default
<Optical Head>
Shown message
Setting item
Setting range
F/W default
<Page Count Print>
Shown message
Setting item
Setting range
F/W default
<Setting>
Shown message
Setting item
Setting range
F/W default
<Strb Time>
Shown message
Setting item
Setting range
F/W default
* Setting of Strb Time is enabled only when the Optical Head is set at D600-4W.
Chapter C Maintenance Utility GUI Manual
Print Position
Corrects the start position of print.
-4.00 mm~ +3.5mm
0.00mm
LED Head Marking No.
Adjust the light exposing time of LED Head.
600 DPI: 155-020 (No. 1~ No.32)
300 DPI: No. 1~No.32
212-228 (300 dpi-No.17
Head Type
Sets the correction method in correction head at 600 DPI.
TYPE1/TYPE2D2/TYPE2D4
TYPE2D4
Optical Head
Sets
D300-1W/ D300-2W/ D600-4W
D300-1W
Page PRT
Selects enable/disable of Page Count print in menu printing.
DISABLE/ ENABLE
DISABLE
Setting
Adjusts the current transmission value.
-2 / -1 / 0 / +1 / +2
0
Strb Time
Sets the strobe time.
0.54, 0.50, 0.56, 0.40
0.50
Service Guide OKIPAGE 10e
Page: 101
Advertisement
Table of Contents
Troubleshooting
