Installing The Water Pump - Yamaha FZ6RC Service Manual

coolant onto its out surface.
Install the oil seal with a socket that matches its
G
outside diameter.
2. Install:
Water pump seal "1"
G
ECA14080
NOTICE
Never lubricate the water pump seal surface
with oil or grease.
TIP
Install the water pump seal with the special
G
tools.
Before installing the water pump seal, apply
G
Yamaha bond No.1215 "2" to the water pump
housing "3".
Mechanical seal installer
90890-04078
Water pump seal installer
YM-33221-A
Middle driven shaft bearing driver
90890-04058
Bearing driver 40 mm
YM-04058
Yamaha bond No. 1215
90890-85505
(Three Bond No.1215®)
A. Push down
4. Mechanical seal installer
5. Middle driven shaft bearing driver
3. Install:
Bushing "1"
New
G
New
6-12
Gasket "2"
New
G
TIP
Before installing the bushing, apply tap water or
coolant onto its outer surface.
2
4. Measure:
Impeller shaft tilt
G
Out of specification → Repeat steps (3) and
(4).
ECA20S1005
NOTICE
Make sure the bushing and gasket are flush
with the impeller.
Impeller shaft tilt limit
0.15 mm (0.006 in)
1. Straightedge
2. Impeller
5. Install:
Impeller shaft
G
Circlip
New
G
O-ring
New
G
Copper washer
New
G
Water pump cover
G
Water pump cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
EAS26590

INSTALLING THE WATER PUMP

1. Install:
O-ring
New
G
WATER PUMP
1
1
2