Fault code No.
Symptom
Fail-safe action
Diagnostic monitoring
code No.
Meter display
Checking method
Order
1
2
3
4
30
Turnover of vehicle
Engine startup: Impossible
Riding: Impossible
08
The lean angle sensor value is indicated.
0 to 5.0 V
The vehicle is in a vertical position: 0.4–1.4 V
The vehicle is turned over: 3.7–4.4 V
Remove the lean angle sensor, tilt the vehicle more than 65 degrees, and
check the meter indication value.
Item/components and
probable cause
Turnover of vehicle
Sensor installation status Check for a loose mount-
Lean angle sensor mal-
function
ECU malfunction
8-48
FUEL INJECTION SYSTEM
Check or maintenance
job
Raise the vehicle to the
upright position.
ing, pinched mounting, or
hard mounting.
Make sure that the
mounting position is cor-
rect.
Diagnostic mode (Code
No. D08)
In vertical position:
0.4–1.4 V
When turned over:
3.7–4.4 V
Indication is incorrect. ⇒
Replace the lean angle
sensor. Refer to
"CHECKING THE LEAN
ANGLE SENSOR" on
.
page 8-87
Replace the ECU.
Sensor inspection
procedure
Place the main switch to
the ON position.
(however, the engine
cannot be restarted
unless the main switch is
first turned OFF)