Yamaha FZ6RC Service Manual page 230

2. Tighten:
Generator rotor bolt "1"
G
Generator rotor bolt
75 Nm (7.5 m·kgf, 54 ft·lbf)
TIP
While holding the generator rotor "2" with the
G
sheave holder "3", tighten the generator rotor
bolt.
Do not allow the sheave holder to touch the
G
projection on the generator rotor.
Sheave holder
90890-01701
Primary clutch holder
YS-01880-A
3. Apply:
Sealant
G
(onto the stator coil assembly lead grommet)
Yamaha bond No. 1215
90890-85505
(Three Bond No.1215®)
4. Install:
Stator coil
G
Stator coil bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
LOCTITE®
5. Install:
Generator rotor cover
G
GENERATOR AND STARTER CLUTCH
TIP
Tighten the generator rotor cover bolts in stages
and in a crisscross pattern.
6. Fill:
Engine oil
G
Refer to "CHANGING THE ENGINE OIL" on
page 3-23.
7. Install:
Fuel tank
G
Refer to "FUEL TANK" on page 7-1.
Passenger seat/Rider seat
G
Refer to "GENERAL CHASSIS" on page 4-1.
5-32
Generator rotor cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
LOCTITE®