Code Entry; Code List Entry - RCA RCU1010 User Manual

Code Entry

Code List Entry

In order for the RCU1010 to control your components (TV, VCR, DVD, etc.), you must program it with
the corresponding code from the Code Lists. This enables the remote to control your component with
the proper commands. If your TV, VCR, DVD, or satellite receiver is an RCA, ProScan or GE brand, the
RCU1010 may not need any programming to control it. To program the remote with the codes for your
components, you can use one of three methods: Code List Entry, Code Search or Code Autosearch.
You can enter codes in your RCU1010 from the Code Lists using the SETUP key. (Refer to the Code Lists
of the most popular brands at the end of this User's Guide.) When you enter a valid code for any given
mode (e.g., when you enter a valid code for a TV), the default key labels are displayed on the touchscreen,
and any previously Learned functions for that mode are deleted. The mode is reset to its power-on
default state.
To enter a code directly from one of the Code Lists, follow these steps:
1. Manually turn on the component to be controlled
(TV, VCR, DVD, etc.).
2. Press and hold the SETUP key on the rubber keypad for
2-3 seconds until the LED indicator light remains on and
the touchscreen shows the Code Setup Mode? Screen.
3. Release the SETUP key.
7