Rca All Power Off Feature; Glossary - RCA RCU1010 User Manual

RCA All Power Off Feature

The RCA All Power Off feature is available in all normal operating modes. If the ON•OFF key on the
rubber keypad is pressed twice consecutively (within two seconds), all RCA equipment is turned off.
The touchscreen shows the Power Off Screen while this routine is active.
Glossary of Terms
AUDIO FEATURES
AM•FM KEY
The AM•FM allows you to select the AM or FM band on your AUDIO system.
CENTER, FRONT, REAR & TEST KEYS
You can adjust the levels of the center, front and rear speakers by using the LCD UP
ARROW/DOWN ARROW keys. The TEST key is used when you make speaker balance
adjustments to maximize the performance of your AUDIO system.
CD, TAPE, TUNER, TV, VIDEO KEYS
Use the CD, TAPE, TUNER, TV and VIDEO keys to select the component you want to control.
DSP KEY
When the Digital Signal Processing (DSP) Mode is enabled, pressing this key allows you
to cycle through the various DSP Modes.
UP ARROW / DOWN ARROW KEYS
The UP and DOWN ARROW keys are used to make adjustments on delay time, center
speaker output level, rear speaker output level, front speaker level or subwoofer level.
PROG KEY
The PROGRAM key is used to program your AUDIO preset channels.
BACKLIGHT KEY
The BACKLIGHT key turns the LCD Backlighting on or off.
COMPONENT KEYS
The component keys on the LCD change the component currently being controlled by the remote
(e.g., TV, VCR, CABLE, SAT, DVD, AUDIO 1, 2, 3, 4). The AUDIO 1-4 keys allow you to program
your CD, TUNER, TAPE and AMP player.
ENTER KEY
The LCD ENTER key is used to complete channel selections for some brands of TVs. It is also used
to complete the highlighted sections when navigating through new screens.
GO BACK KEY
The GO BACK key allows you to go to the previous channel you selected. It operates the same
as the Last Channel, Previous Channel or Recall keys on your existing remote.
GUIDE KEY
If your component is equipped with this feature, the LCD GUIDE key brings up the on-screen
program listing.
INPUT KEY
The LCD INPUT key selects the video inputs of your component, if the component is equipped
with this feature.
LEARN
The LEARN feature is used to supplement the preprogrammed Code Lists. The standard Code Lists
provide most of the functions needed, but you can add a small number of additional functions of
your choice.
LED INDICATOR LIGHT.
The Light Emitting Diode (LED) indicator light, located at the upper right-hand side of the RCU1010
unit, lights up whenever a rubber key or any LCD touchscreen key is pressed. The LED indicator
light flashes and beeps three times (approximately two seconds) to indicate any error condition.
28