Code Search - RCA RCU1010 User Manual

Code List Entry (continued)
4. Press and release the desired component key (TV, VCR,
SAT, etc.) on the LCD touchscreen. For AUX, press and release
the LCD AUX key followed by the desired component key to
be programmed under that key.
The AUX key automatically defaults to CABLE mode
Note:
unless another selection is made.
5. Enter the three-digit code for your component brand from the
corresponding Code Lists at the back of this manual. If your
brand has more than one code listed, begin with the first
code. When a valid code from the list is entered, the LCD
displays the Code Save Success Screen, followed by the Code
Setup Mode? Screen. For an invalid code entry, the LCD
displays the Invalid Entry Made Screen for two seconds
before displaying the Code Setup Mode? Screen. In this case,
no changes are made.
6. Before the code can be tested on the chosen component,
return to normal operation by pressing the LCD EXIT key
and then the LCD OK key on the Exit Setup Screen.
7. With the component on, aim the RCU1010 at the component
and press and release the ON•OFF key. If you have entered
the correct code number for your component, it responds
to the ON•OFF key. If the component responds, no further
programming is required.
8. If your component does not respond, try the next code in the
list for your brand by repeating the procedure starting at step
two. If no other codes exist for your brand, try the Code
Search or Code Autosearch methods.

Code Search

If the component you wish to control does not respond to any of the codes you have entered using
the Code List Entry, you can search the entire Code List for a particular component that might not be
listed in the Code List or might be listed under a different brand.
When you enter a valid code for any given mode (e.g., when you enter a code for a TV), the default
key labels are displayed on the touchscreen and any previously Learned functions for that mode are
deleted. The mode is reset to its power-on default state.
To search for a specific code in one of the Code Lists, follow these steps:
1. Manually turn on the component to be controlled (TV, VCR,
DVD, etc.).
2. Press and hold the SETUP key on the rubber keypad for 2-3
seconds until the LED indicator light remains on and the
touchscreen shows the Code Setup Mode? Screen.
3. Release the SETUP key.
4. Press and release the SETUP key again. The LCD displays
the Code Search Mode? Screen.
5. Press and release the desired component key (TV, VCR, SAT,
etc.). For AUX, press and release the LCD AUX key followed by
the desired component key to be programmed under that key.
Note: The AUX key automatically defaults to CABLE unless
another selection is made.
6. The LCD displays the Code Search Key? Screen. Press and
release the ON•OFF key repeatedly until the component to be
controlled responds to the command and turns off. Press and
release the LCD OK key to save the code. After you install
this code, all key labels and any previously Learned
commands will be reset.
8