Schedules; Permanent Schedules - Security Command XR20 User Manual

Schedules

User Code Level: Master only.
Function: The Schedules function allows you to program the times
at which you normally turn your burglary protection on and off each
day of the week. This information can then be used by the system
to automatically arm or disarm the burglary protection.
Your system may be pre-programmed at installation to allow
automatic arming and disarming. When pre-programmed, you can
enter a schedule for the arming and disarming times.
You can also use the Closing Check/Extend feature with Schedules
to ensure your system is armed by an authorized user at a
specific time. This option sounds the keypad buzzer and displays
CLOSING TIME! when a schedule expires.
premises are required to arm the system or extend the schedule.
If the system is not armed, or the schedule not extended, a report
can be sent to the central station and/or a pager.
When a schedule expires and CLOSING TIME! displays, the keypad
next displays ENTER CODE: -. To silence the keypad buzzer and
extend the schedule for one hour, a user must either enter a valid
user code or present a card to the card reader.
Your system provides you with two different types of schedules:
Permanent schedules are used for automatic arming and disarming
and always occur at the same time until you change or delete
them.
Extend schedules allow an authorized user to extend the present
day's permanent scheduled closing time.
28

Permanent Schedules

User Code Level: Master only.
Use the following steps to set an arming or disarming schedule:
1. Access the User Menu.
2. Press the COMMAND key until SCHEDULES? displays. Press
3. The keypad next displays the day of the week you want
4. The keypad displays OPENING TIME?. Press COMMAND. The
Users still on the
5. The keypad then displays CLOSING TIME?.
6. To clear a schedule, press DELETE and then AM when the
XR20 User's Guide
any Select key. The keypad displays PRM EXT. Select
PRM.
the schedule to start as SUN MON TUE WED. Press the
COMMAND key to show the remaining days of the week and
then Select your choice.
keypad now displays MON – :
want the burglary protection to be turned off. Use a 12 hour
clock only (12:00 to 11:59). Select AM or PM.
COMMAND key. The keypad then displays MON – :
PM. If you want the schedule to be for consecutive days,
Select MON to increment the days of the week. When the
correct day is shown, enter the time you want the burglary
protection to turn on.
opening time is requested.
Press the Back Arrow key to exit the User Menu.
AM PM. Enter the time you
Press the
AM
User Menu