Symptoms - Dalsa PC2-CamLink User Manual

Symptoms

PC2-CamLink board not detected
The board is not seen when an application is started. This is due to a module creation error under IFC
or because the Sapera Server is not present under Sapera.
Note: PC2-CamLink is supported by two different APIs: Sapera LT and IFC. You must install one or
the other. It is not possible for PC2-CamLink to work under both APIs on the same machine. PC2-
CamLink will only work correctly with the last API installed on the machine. This ensures the PC2-
CamLink driver matches the version of the API you are using.
This could stem from a hardware failure, a PCI problem, a plug and play problem, a kernel driver
problem, or a software installation problem. You need to have 'Administrator' privileges to install the
PC2-CamLink software and to follow the troubleshooting guidelines given in this section.
The following sections assume that you have followed the installation procedure described earlier in
this manual and that a PC2-CamLink board is installed in your system.
Part IV: Troubleshooting and Support • 117
PC2-CamLink User's Manual