Sapera Lt Library Installation; Installing Pc2-Camlink Hardware And Driver; In A Windows Xp, Windows Vista, Or Windows 7 System - Dalsa PC2-CamLink User Manual

Sapera LT Library Installation

Note: to install Sapera LT and the PC2-CamLink device driver, logon to the workstation as an
administrator or with an account that has administrator privileges.
The Sapera LT Development Library (or 'runtime library' if application execution without
development is preferred) must be installed before the PC2-CamLink device driver.
•
Insert the DALSA Sapera CD-ROM. If AUTORUN is enabled on your computer, the DALSA
installation menu is presented.
•
If AUTORUN is not enabled, use Windows Explorer and browse to the root directory of the CD-
ROM. Execute launch.exe to start the DALSA installation menu and install the required Sapera
components.
•
The installation program will prompt you to reboot the computer.
Refer to Sapera LT User's Manual for additional details about Sapera LT.

Installing PC2-CamLink Hardware and Driver

In a Windows XP, Windows Vista, or Windows 7 System

•
Turn the computer off, disconnect the power cord (disables power standby mode), and open the
computer chassis to allow access to the expansion slot area.
•
Install the PC2-CamLink into a free PCI slot.
•
Close the computer chassis and turn the computer on. Driver installation requires administrator
rights for the current user of the computer.
•
Windows will find the PC2-CamLink and start its Found New Hardware Wizard. Click on the
Cancel button to close the Wizard Application.
•
Insert the DALSA Sapera CD-ROM. If AUTORUN is enabled on your computer, the DALSA
installation menu is presented. Install the PC2-CamLink driver.
•
If AUTORUN is not enabled, use Windows Explorer and browse to the root directory of the CD-
ROM. Execute launch.exe to start the DALSA installation menu and install the PC2-CamLink
driver. Note, if you are using Windows Vista or Windows 7 with the User Account Control
feature enabled, a dialog is displayed when you execute launch.exe; click Allow to continue with
the driver installation.
•
Choose the device driver setup type, full installation (required for application development) or
runtime installation (supports application execution only).
•
When using Windows XP, if a message stating that the PC2-CamLink software has not passed
Windows Logo testing is displayed, click on Continue Anyway to finish the PC2-CamLink
driver installation. Reboot the computer if prompted to do so.
8 • Part I: PC2-CamLink Board
PC2-CamLink User's Manual