Installation Warnings; Packing List; Additional Items Required; Items Packed With The Face - Travis Industries 31 DVI GSB2 Owner's Manual

Installation (for qualified installers only)

Installation Warnings

 Failure to follow all of the requirements may result in property damage,
bodily injury, or even death.
 This heater must be installed by a qualified installer who has gone through
a training program for the installation of direct vent gas appliances.
 The installation must conform with local codes or, in the absence of local
codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or the
National Gas and Propane Installation Code, CSA B149.1..
 In Manufactured or Mobile Homes must conform with Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280, or, when such a
standard is not applicable, the Standard for Manufactured Home
Installations, ANSI/NCSBCS A225.1. This appliance may be installed in
Manufactured Housing only after the home is site located.
 The heater is designed to operate on natural gas, or propane (LP).
 All exhaust gases must be vented outside the structure of the living-area.
Combustion air is drawn from outside the living-area structure.
 Notify your insurance company before hooking up this heater.
 The requirements listed below are divided into sections. All requirements
must be met simultaneously. The order of installation is not rigid – the
qualified installer should follow the procedure best suited for the installation.

Packing List


Propane Conversion Kit

Cove Covers

Additional Items Required


Media Set (order one of the following):

Driftwood Log Set (sku 94500548) - See installation instructions included with the logs.

Fyre-Stone Stone Set (sku 94700732) - See instructions included with the stones.

Log Set (sku 94400991) – See instructions included with the logs.

Faceplate

Simpson Duravent 6-5/8" to 3" & 3" Co-Linear Adapter with flashing

3" Diameter Gas Liner (2)

Direct Vent Cap (Use Simpson Duravent High Wind Cap)

Gas Line Equipment (shutoff valve, pipe, etc.)

Items Packed with the Face


Face with attachment hardware (Note: use the cove covers included with the heater)

Face Installation Instructions

Order of Installation

1 If the heater is to use propane, install the propane conversion kit (see page 35).
2 Install gas line into the fireplace (do not connect to unit).
3 Position the heater.
4 Connect the gas line and gas vent to the appliance.
5 Install the optional surround panels and trim. Attach the on/off switch.
6 Follow the instructions under "Finalizing the Installation" on page 23.
© Travis Industries

"Fireplace Altered" tag (attach to the fireplace)

Button Plug for Surround Panels (see page 18)

Top Convection Deflector
4140813
7
100-01296