Panel Description - Icom IC-A24E Instruction Manual

q BACKLIGHT SWITCH [LIGHT]
Turns the backlight for display and keypad ON or OFF.
w PTT SWITCH [PTT] (p. 9)
Push and hold to transmit; release to receive.
• " " appears on the function display while transmitting.
e VOLUME [VOL] (p. 9)
Adjusts the audio level.
r TUNING DIAL [DIAL] (pgs. 8–12)
➥ Rotate [DIAL] to select the desired frequency, BANK
number and memory channel.
➥ Rotate [DIAL] to set the squelch level and beep tone
level.
t ANTENNA CONNECTOR [ANT] (p. 1)
Connect the supplied antenna here.
y RECALL CHANNEL UP/DOWN KEYS [Ω]/[≈] (p. 10)
➥ Push to enter the recall function mode.
➥ Push to call the stored frequency in the recall
mode.
➥ Push
, then push [Ω]/[≈]to replace stored
recall frequencies to back or front.

PANEL DESCRIPTION

u SQUELCH KEY [SQL] (p. 8)
➥ Push [SQL], then rotate [DIAL] to select the
squelch level.
• 24 squelch levels and squelch open (0) are available.
i POWER SWITCH [PWR] (pgs. 9, 29)
➥ Push and hold for 2 sec. to turn the power ON
or OFF.
➥ While pushing and holding [MR•
[PWR] to enter the cloning function mode.
o EXTERNAL SPEAKER AND MICROPHONE JACKS
[MIC/SP] (p. 33)
If desired, connect an OPC-499
headset.
!0 FUNCTION KEY [
]
Push to call up the function indicator, "
push another key to access its secondary func-
tion.
• " " appears for 3 sec. after
time pushing again cancels the indication.
NOTE: In general, "
other key is pushed to activate a secondary
function. However, some keys which have more
than one secondary function, (such as [DUP]),
do not cancel "
cally disappears after 3 sec.
2
], push
MW
and
HEADSET ADAPTER
", then
is pushed; at this
" disappears when an-
". In this case, " " automati-
2
3