Notification; Sensor - APEC TVR 3000 User Manual

Notification

Under Event Notification, you may choose
to be alerted by a red border, system beep*
and/or via SMS or email*.
(NOTE: *Some notifications might not be available.)
Procedure Using the Remote Controller or Control Panel:
1. In SETUP, select Event->Notification.
2. Press [LEFT], [RIGHT], [+] or [-] to select a camera or ALL cameras.
3. Press [DOWN] to move to Red Border.
4. Press [LEFT], [RIGHT], [+] or [-] to check or uncheck Red Border.
5. Press [DOWN] to move to SMS.
6. Press [LEFT], [RIGHT], [+] or [-] to check or uncheck SMS. When checked, you may specify the
mobile number. The On-Screen Keyboard will appear automatically.
7. Use the On-Screen Keyboard to specify a mobile number.
8. Press [DOWN] to move to Email.
9. Press [LEFT], [RIGHT], [+] or [-] to check or uncheck Email. When checked, you may specify the
email address. The On-Screen Keyboard will appear automatically.
10.Use the On-Screen Keyboard to specify an email address.
11. Press [ENTER] or [SELECT] to save changes and exit. Or, press [SETUP] or [BACK] to exit without
saving.
48

Sensor

Under Sensor setup, you can modify
sensor settings, view sensor logs and
enable sensor onboard.
Procedure Using the Remote Control-
ler or Control Panel:
1. In SETUP, select Event->Sensor.
2. In Sensor Setup, use [UP], [DOWN], [LEFT] or [RIGHT] to navi-
gate through the menu.
3. Use [ENTER], [SELECT], [+] or [-] to change the values. The
status may be enabled or disabled. The normal state may either
be close or open. Note that all changes you make are always
saved.
4. When you are done, press [SETUP] or [BACK].
Under sensor logs, you can view the list of recorded information or
events collected by a sensor (or set of sensors).
It will automatically log the
sensor(s) that triggered and
the date it triggered.
Sensor On-board option de-
termines the sensors you are
using. Enabling it means you will use the built-in 4 sensors on the
board, while disabling it means you will use the 8 sensors in the
extended IO card (i.e. if you add an IO card to the board).
49