Sensor To Camera; Sensor To Ptz; Camera To Relay; Sensor To Relay - APEC TVR 3000 User Manual

Sensor to Camera

This mapping allows you to match sensors
and cameras.
Procedure Using the Remote Controller
or Control Panel:
1. In SETUP, select Mappings->Sensor To
Camera.
2. In Sensor To Camera Setup, use [UP], [DOWN], [LEFT] or [RIGHT] to navigate through the menu.
3. Use [ENTER], [SELECT], [+] or [-] to change the values. An "x" means mapped. Note that all chang-
es you make are always saved.
4. When you are done, press [SETUP] or [BACK].
Note: You can map more than 1 camera per sensor. Conversely, you can map more than 1 sensor per camera.

Sensor to PTZ

This mapping allows you to match sensors
to PTZ cameras. If a sensor is matched
with a PTZ camera, then when the sensor is
triggered, the PTZ camera will move to the
preset defined under Preset On and once
the sensor is de-activated, the PTZ camera
will move to preset defined under Preset Off.
The Dwell Time indicates the length of time
from when the PTZ camera moves from Present On to Preset Off
Procedure Using the Remote Controller or
Control Panel:
1. In SETUP, select Mappings->Sensor To
PTZ Camera.
2. In Sensor To PTZ Camera Setup, use
[UP], [DOWN], [LEFT] or [RIGHT] to
navigate through the menu.
3. Use [ENTER], [SELECT], [+] or [-] to
change the values. There are 9 possible
presets. (See SETUP->PTZ->Camera.)
An "x" means there is no preset selected.
Note that all changes you make are always saved.
4. When you are done, press [SETUP] or [BACK].
NOTE: Dwell settings can be adjusted from 5 to 90 secs. Please ensure that sensors are enabled; refer to page 49.
52

Camera to Relay

This mapping allows you to match cameras
and relays.
Procedure Using the Remote Controller
or Control Panel:
1. In SETUP, select Mappings->Camera
To Relay.
2. In Camera To Relay Setup, use [UP],
[DOWN], [LEFT] or [RIGHT] to navi-
gate through the menu.
3. Use [ENTER], [SELECT], [+] or [-]
to change the values. An "x" means
mapped. Note that all changes you
make are always saved.
4. When you are done, press [SETUP] or
[BACK].
Note: You can map more than 1 camera per re-
lay. Conversely, you can map more than 1 relay
per camera.

Sensor to Relay

This mapping allows you to select which
relay(s) will be activated when selected
sensor is triggered.
Procedure Using the Remote Controller
or Control Panel:
1. In SETUP, select Mappings->Sensor
To Relay.
2. In Sensor To Relay Setup, use [UP],
[DOWN], [LEFT] or [RIGHT] to navi-
gate through the menu.
3. Use [ENTER], [SELECT], [+] or [-]
to change the values. An "x" means
mapped. Note that all changes you
make are always saved.
4. When you are done, press [SETUP] or
[BACK].
Note: You can map more than 1 sensor per relay. Conversely, you can map more than 1 relay per sensor.
53