Watermark; Event - APEC TVR 3000 User Manual

To set recording time for each time interval using the Remote Controller or Control Panel:
1. In SETUP, select Recording->Schedule.
2. In Recording Schedule Setup, use [UP],
[DOWN], [LEFT] or [RIGHT] to navigate
through the menu.
3. Use [ENTER], [SELECT], [+] or [-] to
change values. On the remote controller,
there are shortcuts available:
1: Set all to Sensor recording
2: Set all to Motion recording
3: Set all to Event recording
4: Set all to Continuous recording
5: Disable all recording
Focus +: Change values of the current column
Focus -: Change values of the current column
Iris +: Change values of the current row
Iris -: Change values of the current row
Note that all changes you make are always saved.
4. When you are done, press [SETUP] or [BACK].
46

Watermark

This DVR can add watermark to key frames
in the recorded video. Watermarking pro-
tects the video from tampering.
To enable/disable watermark:
1. Go to Setup->Recording and select
Watermark.
2. Press either [ENTER], [SELECT], [+] or [-] to enable or disable watermark. A checkbox means it's
enabled, while a cross will mean otherwise.

Event

Event setup allows user to configure
notifications and settings for event(s) to
be triggered.
Procedure Using the Remote Controller or Control Panel:
1. In SETUP, use [UP] or [DOWN] to select Event.
2. Press [ENTER], [SELECT] or [RIGHT] to expand the sub-menus.
3. To view/modify settings under the sub-menus, use [UP] or [DOWN] to select the sub-menu and
press [ENTER] or [SELECT].
4. In the sub-menu, navigate by pressing [UP] or [DOWN], [LEFT] or [RIGHT] to choose which option
to modify.
5. Press [ENTER] or [SELECT] to select a sub-menu.
47