Table of Contents
Advertisement
→When the vehicle is in operation, the surface of the charger will become
slightly hot.
→In case of emergency, let go of the finger lever control and the vehicle will
come to a stop.
B. Controller Display
The controller display is a multifunction visual display. It can provide a lot of
information of the vehicle.(shown as Fig 17)
＃When the needle falls into the red sector your batteries are low in power and
need to be recharged. It is wise to recharge your batteries when the needle
enters the red zone Remaining fuel needle only goes lower when using the
battery, regardless the battery voltage. The remaining fuel needle goes higher
only when recharging battery in
＃Power ON/OFF will flash when the battery voltage is lower than 23.3V.
That means the batteries need to be charged.
＃System will lock when the vehicle without using over 30 minutes. You need
to remove the key and insert the key to restart the power of scooter.
C. Free-Wheeling:
Because the motors are designed to engage the electromagnetic brakes when the
vehicle is not in use or when the power is OFF. They also have a manual feature
that allows them to "free-wheel". Free-wheeling is accomplished by adjusting the
free-wheeling levers to the free-wheeling position.(See Fig 19)
Warning
! →Never free-wheel your power scooter on a slope.
→Never free-wheel the motors while operating your vehicle.
→Always remember to engage the motors before turning the power ON.
Free Wheeling Lever
progress.
(Fig 19)
13
Advertisement
Table of Contents
