Table of Contents
Advertisement
→When the vehicle is in operation, the surface of the charger will become slightly
warm.
→In case of emergency, let go of the finger lever control and the vehicle will
come to a stop.
B. Controller Display
The controller display is a multifunction visual display. It can provide a lot of
information of the vehicle.(shown as Fig 13)
＃When the needle falls into the red sector, your batteries are low on power and
need to be recharged. It is wise to recharge your batteries when the needle
enters the red zone. The remaining battery needle only goes lower when using
the battery, regardless the battery voltage. The remaining battery meter needle
goes higher only when recharging battery in
＃System will power off when the battery voltage is lower than 21.0V.
＃System will lock when the vehicle is not in use over 30 minutes. You need
to remove the key and insert the key to restart the scooter.
C. Free-Wheeling:
The motors are designed to engage the electromagnetic brakes when the vehicle is
not in use or when the power is OFF. They also have a manual feature that allows
them to "free-wheel" so the scooter can be moved without turning it on.
Free-wheeling is accomplished by adjusting the free-wheeling levers to the
free-wheeling position.(See Fig 15).
Warning
!→Never free-wheel your power scooter on a slope.
→Never free-wheel the motors while operating your vehicle.
→Always remember to engage the motors before turning the power ON.
(Fig 15)
progress.
Free- Wheeling
Lever
13
Advertisement
Table of Contents
