Enabling Adapter Management; Upgrading 7111 Firmware Using Adapter Management - Ruckus Wireless MediaFlex 7811 User Manual

Adapter Management
8. Click Update Settings to save your settings.
Figure 41—Disabling adapter management

Enabling Adapter Management

To enable adapter management, do the following:
N – With Release 4.2 and later, adapter management is enabled by default upon 7111 provisioning with the 7811.
OTE
This procedure assumes that adapter management is currently disabled.
1. Connect a PC to the 7111's Ethernet port.
2. If necessary, change the IP address of your PC to an address in the same subnet (192.168.2.x) as the 7111.
3. Login to the 7111 using the IP address, user name, and password located on the label on the bottom of the
adapter.
4. Go to Administration :: Management.
5. Select the 'Enabled" radio button for Link-Local Adapter Management.
6. Click Update Settings to save your settings.

Upgrading 7111 Firmware using Adapter Management

N – This procedure assumes adapter management is currently enabled.
OTE
1. Login to the 7811 Web user interface.
2. Go to Status :: Wireless.
3. Click the Video WLAN tab. In the Connected Devices table, note the Ruckus Adapter Management column.
4. Click the STA WebServer link. A separate browser window opens to the 7111's Web user interface login
page.
5. Login to the 7111 using the appropriate user name and password.
6. In the 7111 Web user interface, go to Maintenance :: Upgrade.
7. Follow the instructions in the 7111 user guide to perform the firmware upgrade.
62 Ruckus Wireless MediaFlex 7811 Access Point