CyberData 11146 Operation Manual page 30

On the Network Configuration page, enter values for the parameters indicated in
Web Page Item
Stored Network Settings
IP Addressing
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
DHCP Timeout
DHCP Timeout in seconds
Current Network Settings
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
On this page:
1. Specify whether you use Static or DHCP IP Addressing by marking the appropriate radio
2. For Static IP Addressing, also enter values for the following parameters:
•
•
•
3. Click Save when you are finished.
4. Click Reboot for the new settings to take effect.
CyberData Corporation
Table 2-7. Network Configuration Parameters
button. Then, if you select Static, go to
The V3 Paging Server's IP Address: The V3 Paging Server is delivered with a factory
default IP address. Change the default address to the correct IP address for your system.
The Subnet Mask.
The Default Gateway.
Description
Shows the settings stored in non-volatile memory.
Select either DHCP IP Addressing or Static IP Addressing by
marking the appropriate radio button. If you select Static, configure
the remaining parameters indicated in
go to Step 3.
Enter the Static IP address.
Enter the Subnet Mask address.
Enter the Default Gateway address.
Enter the DNS Server 1 address.
Enter the DNS Server 2 address.
Enter the desired timeout duration (in seconds) that the device will
wait for a response from the DHCP server before defaulting back to
the stored static IP address.
Note: A value of -1 will cause the device to retry indefinitely and a
value of 0 will cause the device to reset to a default of 60 seconds.
Shows the current network settings.
Shows the current Static IP address.
Shows the current Subnet Mask address.
Shows the current Default Gateway address.
Shows the current DNS Server 1 address.
Shows the current DNS Server 2 address.
Click on the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
Step 2.
930427G
Setting Up the V3 Paging Server
Configure the Network Parameters
Table 2-7.
Table 2-7
. If you select DHCP,
Operations Guide
22