Basic Setup; Things To Consider Before Installation; Mounting And Wiring The Cameras - SVAT CV300 - 4CH Instruction Manual

BASIC SETUP

THINGS TO CONSIDER BEFORE INSTALLATION

• The camera should be installed 8 to 13ft above the area to be monitored
• Ensure there are no obstructions in the camera's view to maximize viewing area
• Ensure that the adjustable sunshade is positioned to avoid glare and position camera away from direct
sunlight or indoor lighting
• Decide whether the camera will be wall-mounted, ceiling mounted or sit on a desk/table top. If wall or ceiling
mounting, use the mounting hardware in the package. We recommend that the mounting bracket is secured
using the included screws for all installations
• This camera comes with 60ft of video/power wire. Please make sure that you mount the cameras no more
than 60ft from the TV/monitor/VCR/DVR. If longer wiring distance is required, 60ft extensions can be
purchased (CVW62)
• We recommend using a surge protected power bar or UPS to protect the camera's internal circuitry
MOUNTING THE CAMERAS
Follow these instructions for the installation of each camera. (The 60ft video/power wire has two connections: one for
video out, and one for power.)
1. Choose the mounting location for your camera. The
camera can be adjusted for each scenario by rotating
the camera and changing the angle of the mount
to the required viewing position.
2. Screw the mounting bracket into the camera's
mounting hole, turning it clockwise.
3. Mount the camera in the desired location no more
than 60ft from the DVR unless you have purchased
camera extension cables.
4. Adjust cameras to the desired viewing angles.
5. Tighten the thumb screw until tightly secure.
WIRING THE CAMERAS
Follow these instructions for the installation of each camera. The 60ft video/power wire has three connections: one
for video out (yellow RCA), one for power (red power jack), and one to connect to the camera (4PIN DIN). All three of
these connections need to be connected properly for the cameras to function.
1. Plug the 4PIN DIN
female connection on
the camera into the
4PIN DIN male
connection on the 60ft
video/power wire.
CV300 - 4CH
2. Plug the included 4
port power supply
cable into the red
power jack located on
the 60ft video/
power wire.
SVAT ELECTRONICS
now you can see
7