Receiver Installation - Spektrum AR6410T User Manual

AR6410T Features and Ports
Antenna
Rudder
(CH4) servo
+ -
Receiver Installation
It is recommended to use double-sided foam tape strips and/or minimal hot glue
in the corners to install your receiver in the fuselage. The servos need to be in
the appropriate position to attach to and drive the elevator and rudder pushrods.
Installation will vary depending upon application.
Servos
The AR6410T incorporates integrated servos, but optional Spektrum servos are
also available. Using any servo other than a Spektrum servo will cause damage to
the receiver and/or the servo and may void the warranty.
+ - + -
ESC Brushed
Optional Servoa
7
Dual Brushed Motor output
Battery input
Aileron (CH2)
Reversed
Aileron (CH2)
or Aux1 (CH6)
Elevator (CH3)
servo
X-Port (all 4 pins)
OR Gear (CH5)
(lower 3 pins)
EN