Spektrum AR6410T User Manual page 8

EN
Installing and Plugging in the Optional Servos
Use double-sided foam tape strips and/or minimal hot glue to mount the servos
in place. The servos need to be in the appropriate position to attach to the corre-
sponding pushrods. Plug the servo leads into the appropriate servo ports in the
receiver noting the polarity of the servo connector. Installation will vary depending
upon application.
Smart Bind™
The AR6410T receiver must be bound to the transmitter before it will operate.
Binding is the process of programming the receiver of the control unit to recognize
the GUID (Globally Unique Identifier) code of a single specific transmitter. The
AR6410T features Smart Bind. When the receiver is first powered, the receiver will
look for the signal of its previously bound transmitter for 5 seconds. If no signal is
found, the receiver will automatically go into bind mode, indicated by the flashing
LED.
Binding
1. Make sure the flight battery is fully charged.
2. Confirm the flight battery is disconnected from the receiver/ESC unit and the
transmitter is turned off.
3. Plug the flight battery into the receiver' s battery connector. After 5 seconds the
LED on the receiver unit will begin flashing, indicating it is in bind mode.
4. After verifying the LED is flashing on the receiver, follow the steps necessary that
allow your transmitter to enter bind mode. (See your transmitter' s manual)
5. If you entered bind mode correctly, you will see a solid LED within about 10
seconds. You should now be bound to the transmitter and have full control and
function.
LED
8