Spektrum AR6410T User Manual page 9

After Binding
Once the system is bound, the transmitter should always be turned on first and
then the receiver to prevent the receiver from re-entering bind mode. If your recei-
ver inadvertently enters bind mode, simply unplug the battery from the receiver and
reinstall with the transmitter remaining on.
Advanced Programming Features
The following programming features are only recommended for advanced radio
users. To safely accomplish advanced programming feature changes, please enlist
the use of a helper; one person to hold the aircraft to prevent unintended flyaways,
and a second person to make the changes on the transmitter. The procedures
below apply to all compatible transmitters. Prior to making any advanced program-
ming feature changes it is necessary to:
Computer Radios like the DX6i, DX7 amd DX8
1. Choose an empty model location
2. Select model type ACRO
3. Perform a model reset
4. Set all channels to normal reversing
5. Ensure a successful bind has been established
NOTICE: All changes made in advanced programming must start with the receiver
powered down to prevent the motor from running unexpectedly.
Reversing Servos
Servo reversing may be achieved using the servo reversing function of your
transmitter, or as certain advanced applications require it, you may reverse the
actual servos by following the instructions and diagrams below.
Reversing The Servos on the Receiver Board
This feature reverses the servos at the board level, making it useful for implemen-
ting features (such as elevons) while using transmitters with limited programming
options.
NOTICE: All changes made in advanced programming must start with the receiver
powered down to prevent the motor from running unexpectedly.
To safely accomplish advanced programming feature changes, please enlist the
use of a helper. One to hold the aircraft to prevent unintended flyaways, and one to
make the changes on the transmitter.
Sticks must be held in this position while the transmitter is on and the
receiver is off.
1. Ensure a successful bind was completed
2. Turn transmitter on
3. Move THRO stick to full throttle position
4. Move control sticks to the corresponding position for the servo to be reversed
(see illustration)
9
EN