Spektrum AR6410T User Manual page 11

To Change Channel 6 to a Reversed Channel 2 for Dual Ailerons
or Reversed Channel 2 to Channel 6
To safely accomplish advanced programming feature changes, please enlist the
use of a helper. One to hold the aircraft to prevent unintended flyaways, and one to
make the changes on the transmitter.
Sticks must be held in this position while the transmitter is on and the
receiver is off.
1. Ensure a successful bind was completed
2. Turn transmitter on
3. Move THRO stick to full throttle position
4. Move Control sticks to the corresponding position to change between the
available options (see illustration)
5. While holding this position, plug the battery into the receiver; power receiver
6. The LED on the receiver will go solid and within 5 seconds the LED will flash 3
times quickly, indicating the option is now changed
7. Disconnect flight pack from receiver
8. Turn transmitter off
Mode 1
THRO/RUDD ELEV/AILE
To Change Channel 5 to X-port or X-port to Channel 5
When X-Port is active, CH5 and CH6 are not available; however, reversed aileron
(CH2) is still available.
To safely accomplish advanced programming feature changes, please enlist the
use of a helper. One to hold the aircraft to prevent unintended flyaways, and one to
make the changes on the transmitter.
Sticks must be held in this position while the transmitter is on and the
receiver is off.
1. Ensure a successful bind was completed
2. Plug the X-Port accessory or the optional servo into the X-Port/CH5
3. Turn the transmitter on
4. Move the THRO stick to the full throttle position
5. Move Control sticks to the corresponding position to change between the
available options. (see illustration)
6. While holding this position, plug the battery into the receiver; power receiver
Rev. CH2/CH6
1. Full THRO
2. Up ELEV
3. Left AILE
11
Mode 2
ELEV/RUDD THRO/AILE
EN