Table of Contents
Advertisement
10
Link Mode Configuration
The MicroPiano can be set to respond to certain
MIDI note numbers. This is done by pressing the
Channel button and turning the Data knob while
in CONFIGURATION mode.
If the LED reads
respond to ALL notes sent to it. If the unit is set to
the unit will only respond to EVEN MIDI
note numbers;
will only respond to ODD
notes. By chaining two MicroPianos together with
MIDI THRU and setting one to ODD and the
other to EVN, you can have 64-voice polyphony!
Note: For reference, Middle C on the
MicroPiano is number 60, and notes go up or
down from there.
The default setting for LINK mode is ÒALLÓ
when the MicroPiano is turned on.
Program Change/Enable
You can also enable or disable whether the
MicroPiano will respond to MIDI program
changes. Press Program while in the CONFIG-
URATION mode, and select either ON or OFF,
by turning the Data knob.
ON means the MicroPiano will allow program
(patch) changes, OFF will not allow program
changes. This is useful when there is more than
one MIDI device sharing the same MIDI channel
and you want to send program changes to other
devices, without affecting the MicroPiano, or if
your sequencer is sending program changes that
you wish to ignore with the MicroPiano.
The default setting for PROGRAM
CHANGE/ENABLE is ÒONÓ when the
MicroPiano is turned on.
¥ After you have conÞgured the MicroPiano,
press the Transpose button to return to
normal operation.
, the MicroPiano will
Hide quick links:
Advertisement
Table of Contents
