Epson Stylus Photo R320 Service Manual page 80

EPSON Stylus Photo R320
Reinstalling "Paper Guide, Front"
Make sure that the dowels and the hook of "Paper Guide,
Front" are correctly secured to "Frame, Main".
Hook
Figure 2-62. Reinstalling "Paper Guide, Front"
Make sure that the tabs of "Porous Pad, Paper Guide, Front,
Left" and "Porous Pad, Paper Guide, Front, Support" are
facing straight to downward through the slots of "Paper
Guide, Front".
Make sure that there is no gap between "Paper Guide,
Front" and "Frame, Main".
If any ink leaks on the rib of "Paper Guide, Front", clean it
with a cotton swab. (At this time, take care not to touch
"Porous Pad, Paper Guide, Front" of "Paper Guide, Front"
with the cotton swab.)
Reinstalling "Roller EJ Assy."
Make sure that both left and right "Bushing, 5" are
correctly secured.
Make sure that "Grounding Spring, EJ Left (Right)" is
correctly attached to the both ends of "Roller EJ Assy.".
When installing "PF Timing Belt", do not damage the teeth
of "Spur Gear, 41.48".
Make sure that "Roller EJ Assy." moves smoothly.
DISASSEMBLY AND ASSEMBLY
A D J U S T M E N T
R E Q U I R E D
Dowels
Disassembly
When replacing "Roller EJ Assy.", apply G-26 grease in the
adequate dose to the specified points.
When having removed or replaced "Paper Guide, Front",
implement the following adjustment. (Refer to Chapter 3
"ADJUSTMANT")
1. First Dot Adjustment
2. PW Sensor Adjustment
3. Head Angular Adjustment
4. Bi-D Adjustment
Revision B
80