Removing Cdr Guide Assy - Epson Stylus Photo R320 Service Manual

EPSON Stylus Photo R320

2.3.18 Removing CDR Guide Assy.

External View
C.B.S 3x6 (7-9kgf•cm)
2
CDR Guide Assy.
C.B.S 3x6 (6-8kgf•cm)
1
Ribs
3
Flat Washer Link, CDR Left
Flat Washer
Figure 2-52. Removing "CDR Guide Assy." (1)
DISASSEMBLY AND ASSEMBLY
Support Plate, Frame, Main
1
Acetate Tape
Connector Cable
Link, CDR Right C.B.S 3x6 (6-8kgf•cm)
2
Ribs
C.B.P 3x6 (5-7kgf•cm)
1
Hooks
Figure 2-53. Removing "CDR Guide Assy." (2)
Parts/Units which should be removed before removing "CDR Guide Assy."
Paper Support Assy./Preview Monitor Unit/Housing, Upper/Housing, Middle/
Main Board Unit/ASF Assy./Holder, Shaft Assy./APG Assy./
Print Head/Carriage Unit/Printer Mechanism
Procedure for Removing
1. Take off the acetate tape and release the connector cable of "Star Wheel/ CDR
Sensor".
Ribs
2. Remove the screws (x2) which secure "Support Plate, Frame, Main". Then,
remove "Support Plate, Frame, Main".
3. Remove the screws (x3) which secure "CDR Guide Assy.".
4. Remove the flat washer which secure "Link, CDR Left (Right)" with the
tweezers. Then, Remove "Link, CDR Left (Right)" from "CDR Guide Assy.".
5. Release the ribs (x7) which secure "CDR Guide Assy.", then remove "CDR
Guide Assy." through the right edge.
6. Remove the screws (x2) which secure "CDR Guide, Lower".
7. Slide "CDR Guide, Lower" and then release the hooks (x7). After that,
remove "CDR Guide, Lower".
Disassembly
Hooks
2
CDR Guide, Lower
Revision B
72