Epson Stylus Photo R320 Service Manual page 22

EPSON Stylus Photo R320
Occurrence Timing
Phenomenon Detail
Position of CR
When printing
An error occurs even though "CDR
CDR/DVDR
Tray" is set when printing CDR/DVDR.
-
TROUBLESHOOTING
Table 1-9. Check Points for CD/DVD Tray Error to Each Phenomenon
Faulty Part/
Part Name
1. Check if the contact point of "CDR Tray" with "CDR
Tray Sensor" is cracked.
CDR Tray
1. Check if "CDR Tray Sensor" is connected to CN6 on
"Main Board".
CDR Tray Sensor
2. Check if "CDR Tray Sensor" is damaged.
3. Check if "CDR Tray Sensor Connector Cable" is cut off.
1. Check if any device on "Main Board" is damaged.
Main Board
Unit Level Troubleshooting
Check Point
Contact point
CDR Tray Sensor
Revision B
Remedy
1. Replace "CDR Tray" with a new one.
1. Connect "CDR Tray Sensor" to CN6 on
"Main Board".
2. Replace "CDR Tray Sensor" with a new one.
3. Replace "CDR Tray Sensor" with a new one.
1. Replace "Main Board" with a new one.
22