Epson Stylus Photo R320 Service Manual page 49

EPSON Stylus Photo R320
Reattaching the Main Board Assy
Connector cable for "Star Wheels/CDR Sensor" should be
routed as shown below.
Figure 2-20. Routing connector cable
Screw in the order as indicated at Figure 2-17.
DISASSEMBLY AND ASSEMBLY
Connector Cable
When having replaced "Main Board", implement the
A D J U S T M E N T
R E Q U I R E D
adjustment in the following order. (Refer to Chapter 3
"ADJUSTMENT")
When possible to read data from the old board
1. EEPROM data copy
When impossible to read from the old board
1. Replace "Waste Ink Pads" with new one.
(To count the amount of the waste ink)
2. Market Setting
3. USB ID Input
4. Waste Ink Pad Counter
5. Head ID Input
6. First Dot Adjustment
7. PW Sensor Adjustment
8. Head Angular Adjustment
9. Bi-D Adjustment
10. Offset Input for CR Motor Calorific Limitation
Disassembly
Revision B
49