Titan SF2541 Safety And Operating Manual page 9

ASSEMBLY
The saw must be stable and not move about
in operation. The saw must be mounted on
a level, firm work surface before using.
ROTARY TABLE LOCK HANDLE
To install the rotary table lock handle,place the
threaded stud at the outside of the threaded hole
and turn clockwise to tighten.(See fig2)
DUST EXTRACTION PORT
To reduce build up of saw dust and
maintain efficiency of cutting, the saw may be
connected to a workshop vacuum cleaner via
the dust outlet.
A dust bag is provided for use on your mitre saw.
To install it simply fit the dust bag over the exhaust
port on the upper blade guard. (See fig3)
To empty the dust bag, remove from the dust
exhaust port, open the dust bag by unzipping the
slide fastener.
NOTE:
To ensure optimal dust collecting, empty the dust
bag when it becomes filled to approximately 2/3
of its capacity.
TABLE EXTENSION ROD
To install table extension rod, insert ends of
extensions into the holes in either or both sides
of the base. Secure them in place by tightening
clamp screws on the front face of base. (See
fig4)
HORIZONTAL CLAMP
1.The Horizontal clamp can be fitted on either side
of the saw and is fully adjustable to suit the size of
the workpiece. (See fig5)
2.Do not operate the saw without clamping the
workpiece.
3.Make sure that the horizontal clamp securing
screws are tightened.
4.Warning: Always check your clamping position
does not interfere with any saw operation. Before
switching on, lower the saw head to make sure the
clamp clears the guard and saw head assembly.
Before using your mitre saw be sure to read
the instruction manual carefully.
10" MITRE SAW
Fig 2
Fig 3
Fig 4
Fig 5
Fig 6
SF2541