HearthStone Mansfield 8011 Owner's Manual page 10

(**SEE Manuf. Specs.)
DO NOT CONNECT THIS UNIT TO A CHIMNEY
FLUE SERVING ANOTHER APPLIANCE
•
Single wall connector is 24 MSG or 25 MSG blued
steel stove pipe.
•
Double wall connector (close clearance pipe) which
must be used with a listed factory-built "Type HT"
chimney and may also be used with a masonry
chimney to reduce clearances, is available from
several manufacturers, your dealer can help you
choose. Some air insulated connector pipe models
available are Simpson Dura Vent DVL and
Metalbestos DS. Security, GSW and Ameritec also
have acceptable close clearance connector pipe.
•
When used in a mobile home, a spark arrester is
required. (See page 13)
SINGLE WALL CONNECTOR
HearthStone Quality Home Heating Products Inc ®
CHIMNEY CONNECTOR
CLEARANCE TO COMBUSTIBLES
9
•
Chimney connector shall not pass through floor or
ceiling, nor any attic or roof space, closet or similar
concealed space. Where passage through a wall or
partition of combustible construction is desired, the
installation shall conform with NFPA 211 or
CAN/CSA - B365.
•
It is very important to follow minimum clearances for
chimney connectors to combustibles such as walls,
ceilings, and when installing the stove near non-
combustible surfaces. Typical chimney connector
clearances are outlined below. The single wall
clearances are generic, the Double wall clearances are
for Simpson Dura Vent DVL, CHECK THE
SPECIFICATIONS FROM THE
MANUFACTURER OF YOUR CONNECTOR.
DOUBLE WALL CONNECTOR
Mansfield Model 8011