Mansfield (8011) Wood Stove OWNER'S MANUAL INSTALLATION AND OPERATING INSTRUCTIONS PLEASE READ THIS ENTIRE OWNER’S MANUAL BEFORE YOU INSTALL AND USE YOUR NEW Mansfield WOOD STOVE. To reduce the risk of fire, follow the installation instructions. Failure to follow these instructions may result in property damage, bodily injury, or even death.
Creosote Formation And Need For Removal ................18 Gaskets............................18 Glass.............................. 19 Stone.............................. 19 Cast Iron............................19 TROUBLESHOOTING........................20 ........................21 ROUBLESHOOTING UIDE & O ................22 EPLACEMENT ARTS PTIONAL CCESSORIES ............................23 AFETY ABEL HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
Validate your warranty - return your warranty registration card to HearthStone within 30 days of Locate your stove in a safe, convenient, open area; away purchase. Once your warranty has been validated by from traffic flow, doors, and hallways;...
Clean your chimney system as needed. (See page 18) Be sure the removable ash lip is in place while using the stove. If the ash lip is not installed properly, the hearth may exceed safe temperatures. HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
The stove should not be fired again until the stove, stovepipe, and chimney are all thoroughly inspected for any sign of damage. You must correct any damage before using your stove again. HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
Polished gray soapstone Castings Finish Painted black matte and porcelain enamel colors MANSFIELD MANSFIELD SIDE VIEW FRONT VIEW Polished gray soapstone varies from gray to gray-blue, according to natural composition. HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
Mansfield Wood Stove NPACKING 211 for specifications and complete details. You can HearthStone Stoves packages your Mansfield stove with obtain this information directly from NFPA. the greatest care, so that it ships safely. Under certain circumstances, however, damage can occur during transit National Fire Protection Agency and handling.
If you use a rear heat shield to obtain reduced clearances, you must use the optional rear heat shield manufactured by HearthStone available through your local dealer. Close clearance connector pipe must be tested to UL standards and listed. Check listings of your pipe for actual clearances. Shown below are typical only and specific to Simpson Dura Vent DVL brand.
Page 10
MANUFACTURER OF YOUR CONNECTOR. • When used in a mobile home, a spark arrester is required. (See page 13) CHIMNEY CONNECTOR CLEARANCE TO COMBUSTIBLES SINGLE WALL CONNECTOR DOUBLE WALL CONNECTOR HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
Once the stove is installed at safe built fireplace or masonry) chimney. distances from these combustible surfaces, it is important to maintain these connector clearances for the remainder of the installation. HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
An exterior chimney does not benefit from the warmth of being surrounded by the building, so it typically operates at lower flue HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
An equivalent flue liner must be a listed chimney liner system meeting type HT requirements or other approved material. Interior chimney requirements: At least 2” (51 mm) clearance to combustible structure HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
DO NOT INSTALL IN A SLEEPING ROOM ¦ CAUTION: MAINTAIN THE STRUCTURAL INTEGRITY OF THE MOBILE HOME WALLS, FLOOR, CEILING, AND ROOF WHILE YOUR STOVE IS INSTALLED AND IN USE HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
Once your Mansfield has been set in place, connected, FRONT DOOR HANDLE: A fixed handle is provided to and assembled, you are ready to light a fire. HearthStone operate the front loading door. The 10 o’clock position is Stoves tests each wood stove before we ship, so you open;...
As for stacking, an old Vermonter said, "The spaces between the logs should be large enough for a mouse to get through, but not for the cat that's chasing it." HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
If your stove is not used continuously or has not been temperature rapidly. used in quite some time, follow the break-in procedure at HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
Do not over-fire the stove. (refer to previous section). Results of over-firing can include: warped or burned out internal parts, cracked stones, discolored or warped external parts, and damaged enamel. HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
ASKETS Gasket material should normally be replaced every two to three seasons, depending on stove use. If the door seal is HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
With time and use, a very fine, subtle network of crazed lines may appear seemingly beneath the surface of the enamel. Crazing is a natural predictable process and does not represent a flaw. HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
AN "AIRTIGHT" HOUSE: If your home is super- draft is well established. insulated or especially well sealed, the (infiltration) air HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
Do not over-fire the stove. Monitor stove temperatures. Use ENAMEL CASTING seasoned wood only. Excessive Draft Check the DRAFT. (See page 10) A damper may be required. Operate the stove at a LOW BURN range. HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
U.S. ENVIRONMENTAL PROTECTION AGENCY Certified to comply with July 1, 1990 particulate emissions standards Date of Manufacture 1999 2000 2001 DO NOT REMOVE OR COVER THIS LABEL MADE IN USA 3300-610 HearthStone Quality Home Heating Products Inc ® Mansfield Model 8011...
“Original Purchaser”) the new woodstove manufactured by HearthStone and purchased by the Original Purchaser (the “Woodstove”) against any of the occurrences listed in this document that result from defects in material or workmanship. All obligations of HearthStone under this document commence on the date the Original Purchaser purchases the Woodstove (the “Purchase Date”).
Page 26
12. A defect in any part of the Woodstove if the Original Purchaser fails to comply with HearthStone’s or a Dealer’s request to ship the part or the Woodstove to HearthStone or a Dealer, as the case may be...
Page 27
Woodstove is located. In the event the Original Purchaser refuses to allow a Dealer to make a service call, HearthStone or a Dealer, as the case may be, will request that the Original Owner return the defective part, or the entire Woodstove (if needed), with shipping prepaid, to HearthStone or a Dealer.