Chicago Electric 91757 Assembly And Operating Instructions Manual page 14

2. To adjust the angle of cut loosen the Angle Lock Knob (64). Rotate the Base (76)
to set the angle, using the Scale provided. Then, tighten the Angle Lock Knob to
lock the Base in position. (See Figure H.)
FIGURE H
To Adjust The Rip Guide:
1. The Rip Guide (102) is used for making cuts parallel to a workpiece edge at a
chosen distance. (See Figure I.)
2. To use the Rip Guide (102), loosen the Rip Guide Knob (68). Slide the arm of
the Rip Guide through the openings on each side of the Base (76) and achieve
the desired cutting distance using the Scale. Then, retighten the Rip Guide Knob
to lock the Rip Guide in position. NOTE: The Rip Guide can be used from both
sides of the Base. (See Figure I.)
RIP GUIDE
(102)
FIGURE I
SKU 91757 For technical questions please call 1-800-444-3353
RIP GUIDE KNOB
(68)
ANGLE LOCK KNOB
(64)
BASE
(76)
BASE
(76)
PAGE 14