Lid Safety Lid - Slimline Lid Only; Cleaning And Care - Electrolux EQBL100AS User Manual

10 lid safety leg/cleaning and care electrolux integrated barbecue
Lid safety leg – slimline lid only
To ensure that the user remembers to turn off the gas
before closing the lid, a pivoting safety leg has been fitted.
pivoting safety leg
When closing the lid the safety leg will pivot forward and
rest against the trim surface to prevent the lid closing. After
ensuring the gas has been turned off, to fully close the lid,
the leg needs to be rotated backwards.
pivoting safety leg
warning
THE SLIMLINE LID MUST NOT bE CLOSED wHEN
THE bURNERS ARE OPERATING.
Closing the lid during burner operation can cause
discolouration and damage to the lid and barbecue unit.

Cleaning and care

The Electrolux Integrated barbecue has been constructed
from select grade stainless steel which, if not cared for, may
discolour over time. To keep your barbecue looking its best
we recommend that the cooking surfaces are cleaned after
every use.
warning
Please ensure that your barbecue is switched off and
has cooled down before following the instructions
below.
Cleaning of Stainless Steel components
Hot Plate and Grill
• R emove all solid materials and excess grease from grill
and hotplate using scraper or wire brush
• T o make cleaning easy, the two grill halves can be
removed with the hotplate. For stubborn stains, simply
soak the grill and plate components in hot soapy water
before rinsing thoroughly
• E nsure that all surfaces are dried with a clean dry cloth
Other stainless steel surfaces
caution
Do not use abrasive or caustic cleaners, scourers or
metal scrapers on these stainless steel surfaces as they
may permanently scratch and damage your barbecue.
• W ash all stainless steel components, including the
slimline lid, the roasting hood and control knobs with a
soft dishcloth using hot soapy water
• T he barbecue interior can be wiped down with a soft
cloth in hot soapy water. The rear panel of the interior is
removable for easy cleaning
• E nsure that all surfaces are dried with a clean dry cloth
caution
Take extra care (particularly when cleaning on and
around the control knobs) to ensure that water and
soapy residue do not enter the control panel, where
the valves are or into the burners. Care should also be
taken not to disturb the spark electrode. A distance
of 5mm should be maintained between it and the
burners (see diagram below).
5mm