Positioning; Adjustment Of The Minimal Distance Between The Glass And The Upper Plate (Models Equipped Only); Workplace; Unpacking - Electrolux SPEEDELIGHT Installation And Operating Manual

H.4

Positioning

CAUTION
This appliance is not designed for built-in
installation.
The appliance must be levelled.
Do not obstruct the vent holes of the
appliance.
Unpack the machine, carrying out the following
operations:
1. Wear protective gloves. Refer to "C.9 Personal protection
equipment" for further information.
2. Cut the straps and remove the protective film, taking care
not to scratch the surface if scissors or blades are used;
3. Remove the cardboard top, the polystyrene corners and
the vertical protection pieces.
4. Install the appliance, taking all the safety precautions
required for this type of operation, also respecting the
relevant fire-prevention instructions.
Install the appliance in a ventilated place. Refer to "Safety
Information".
• Do not install the appliance adjacent to any high heat or
grease producing piece of appliance, such as a range top,
griddle, fryer, etc., that could allow radiant heat to raise the
exterior temperature of the appliance.
• For the overall space required and connection dimensions,
refer to the installation diagrams given on the first pages of
this manual.
H.4.1 Adjustment of the minimal distance between the
glass and the upper plate (models equipped only)
• 0 chock: H = approximately 13 mm
• 1 chock: H = approximately 24 mm
• 2 chocks: H = approximately 35 mm
• 3 chocks: H = approximately 46 mm
• 4 chocks: H = approximately 57 mm
NOTE!
The number of chocks is given starting from the
top (see example).
• 4 chocks
• 2 chocks
H.5

Workplace

All the laws, regulations and directives in force in the place of
installation regarding the following must be observed.
20
• Correct lighting of workplaces.
• Safety in the workplace, accident prevention.
• Compulsory signs and signals.
• Hygiene.
• Work zones and separation of paths for hygienic purposes.
• Fire prevention.
• Low air pollution emissions.
H.6

Unpacking

IMPORTANT
Immediately check for any damage caused during
transport. Inspect the packaging before and after
unloading.
• The forwarder is responsible for the goods during transport
and delivery.
• Make a complaint to the forwarder in case of visible or
hidden damage.
• Specify any damage or shortages on the dispatch note.
• The driver must sign the dispatch note: the forwarder can
reject the claim if the dispatch note is not signed (the
forwarder can provide the necessary form).
• For hidden damage or shortages becoming apparent only
after unpacking, request the forwarder for inspection of the
goods within and no later than 15 days after delivery.
• Keep all the documentation contained in the packaging.
• Remove the packaging. Take care when unpacking and
handling of the appliance to not cause any shocks on itself.
H.6.1

Feet installation

H.7

Electrical connection

WARNING
Refer to "Safety Information"
x4
A
B
1
x4
B
A
2