Assembly; Rotary Table Lock Handle; Dust Extraction Port; Extension Rod - Titan SF210JSL Safety And Operating Manual

Turn clockwise to tighten
Fig 1
Fig 2
Fig 3
Fig 4
WARNING! before using your sliding
mitre saw
instruction manual carefully.

ASSEMBlY

Assembly

Rotary table lock handle

To install the rotary table lock handle, place the
threaded stud on the end of the rotary table lock
handle into the threaded hole in the control arm
under work table. Turn clockwise to tighten. See
Fig1.

Dust extraction port

To reduce build up of saw dust and maintain top
efficiency of cutting, the saw may be connected
to a workshop vacuum cleaner via the dust outlet.
The outlet accepts 37mm inner diameter vacuum
hose.
Alternatively saw dust collection can be achieved
by clipping a dust bag on the dust extraction
port.
A dust bag is provided for use on your mitre
saw. To install it simply fit the dust bag over the
exhaust port on the upper blade guard. See Fig2.
To empty the dust bag, remove from the dust
exhaust port, open the dust bag by unzipping the
slide fastener.
Note: To ensure optimal dust collecting, empty the
dust bag when it becomes filled to approximately
2/3 of its capacity.
Table extension rod
To install table extension rod, insert ends of
extensions into the holes in either or both sides
of the base. Secure them in place by tightening
clamp screws on the front face of base. See Fig3.
Vertical clamp
1. The vertical clamp can be fitted on either side of
the saw and is fully adjustable to suit the size of
the workpiece. See Fig4.
2. Do not operate the saw without clamping the
workpiece.
be sure to read the