Table of Contents
Advertisement
¦
WARNING:
HOT WHILE IN OPERATION.
CHILDREN, CLOTHING AND FURNITURE
AWAY.
CONTACT MAY CAUSE SKIN
BURNS.
Please read this entire chapter before lighting your first
fire. It explains the controls and features of your wood
Fireplace Insert, how to choose firewood, and how to
break-in your Fireplace Insert and use it on a daily basis.
C
A
F
ONTROLS
ND
EATURES
WARNING: ONLY OPERATE WITH DOOR FULLY
OPEN OR CLOSED. IF DOORS ARE LEFT PARTLY
OPEN, GAS AND FLAME MAY BE DRAWN OUT OF
THE OPENING, CREATING RISKS FROM BOTH
FIRE AND SMOKE
IF OPERATING WITH DOORS FULLY OPEN, YOU
MUST USE THE ACCESSORY SCREEN AVAILIBLE
THROUGH YOUR HEARTHSTONE DEALER
If operating with the door open, some fuels may create
carbon monoxide, which can be hazardous or fatal to your
health. Do not burn anything but clean dry firewood
FRONT DOOR: The front door allows you to load wood
into your Fireplace Insert; a fixed handle allows you to
operate the front door and allows you to latch the front
door closed. The front door can be reversed to open from
either side. To open the door, lift the handle to the 2
o'clock (or 10 o'clock for RH mounted door) position
and pull the door. To latch the doors, push the door
closed tightly then lower the handle to the 4 o'clock (8
o'clock for RH mounted door) position. Pull on the door
handle to make sure it is properly latched.
Reversing the door (Refer to Figure 9)
To switch the door to open from the right, simply remove
the ash lip assembly, and front facade. Remove the two
Phillips head screws holding the door hinges on (A+B in
Figure 9) (use caution, once the last screw is removed
the door will be loose in your hands) Be careful not to
lose the two hinge rivets.
screwdriver remove the door catch (C in Figure 9) (There
may be spacer washer behind the catch to provide an
adequate seal. Remove the two screws where the hinges
will go on the left side. Rotate the door 180 degrees, and
HearthStone Quality Home Heating Products Inc ®
KEEP
Using a Phillips head
Operating Your
Clydesdale Wood
Fireplace Insert
put the hinges in place. Reattach the door catch on the
opposite side of the front, using the same screws and
spacer washers if necessary.
Figure 9 Reversing the Door
PRIMARY AIR CONTROL: The handle is located on the
front bottom center of the Fireplace Insert. The primary
air control allows you to regulate the amount of air
entering the firebox. Generally, the more air allowed into
the firebox, the faster and hotter the rate of burn;
conversely, less air creates a slower burn. To fully open
the primary air intake, push the handle as far as it will go
to the left toward the firebox; push the handle as far as it
will go to the right, away from the firebox to close the
primary air control.
INSTALLING AND OPERATING THE BLOWER
When using the optional blower, follow the instructions
that are packaged with the blower, to install and operate.
The power cord can be routed to the left or right of the
insert, assuming that you follow the instructions provided.
C
F
HOOSING
IREWOOD
Your Clydesdale Wood Heater is designed to only burn
firewood-also known as cordwood.
¦
CAUTION:
DO NOT USE CHEMICALS OR FLAMMABLE
FLUIDS
SUCH
KEROSENE, CHARCOAL LIGHTER FLUID OR
ENGINE OIL TO START A FIRE. DO NOT USE
CHARCOAL,
LOGS OR ANY OTHER MATERIALS AS FUEL;
THEY ARE NOT SAFE.
GARBAGE.
13
AS
GASOLINE,
PELLETS,
COAL,
ARTIFICIAL
DO NOT BURN
Clydesdale Model 8490
NAPHTHA,
Hide quick links:
Advertisement
Table of Contents
