adaptor before connecting the AC power supply.
PWR indicator will be on and the LCD panel will display "Starting..." once the power
supply is connected. After about 40 seconds, the RUNindicator will flash, indicating
completion of the startup of the encoder.
3.2
LCD Panel and State Indicators
3.2.1 LCD panel
TheLCD panel will display "Starting..." upon startup of the device.The following
information will be shown circularly after successful startup:
Device version number, encoder model, network information (IP address, subnet mask,
gateway), input signal source resolution, CBR/VBR code rate/quality level, audio
sampling rate and audio code rate.
3.2.2 State Indicators
Indicator
PWR
RUN
STATU
3.3
WebInterface Login
After startup of the encoder, you may log in the web interface of the encoder with
Copyright © Shenzhen Reach Tech Co., Ltd.9 / 33
State
On
Off
Flashing regularly
Off
On
Flashing
Off
Indication
Power supply normally connected
Power supply not connected
Flashing once every frame during normal operation
Encoder failure
Video source input available and video source
supported
Videosource input available but video source not
supported
No video source input
REACH ENC1260
User's Manual