Related Manuals for Reach ENC110
Summary of Contents for Reach ENC110
-
Page 1: User Manual
REACH SD Encoder ENC110 User Manual V2.5 2012-01 Copyright© Shenzhen Reach IT Co., Ltd. ... - Page 2 Any part of this document, including the text, image and graph, is the property of Shenzhen Reach IT Co., Ltd. No part of this document shall be copied in any means without the prior written consent of Shenzhen Reach IT Co., Ltd. Reach reserves the right to revise this document without any prior notice.
- Page 3 REACH ENC110 SD Encoder User Manual across any problem that cannot be solved according to the manual, please contact our technical department for solutions. Thank you. Copyright© Shenzhen Reach IT Co., Ltd. 3 / 12 ...
-
Page 4: Table Of Contents
2.6.4 Change encoder IP address ................10 2.6 Parameter Setting ....................11 2.7.1 Video setting ....................11 2.7.2 Audio setting ....................11 2.7.3 Caption setting ....................12 2.7.4 PTZ setting and control ................... 12 Copyright© Shenzhen Reach IT Co., Ltd. 4 / 12 ... -
Page 5: Product Overview
1.1 Product Introduction The SD encoder (ENC110) is the special hardware equipment developed by Shenzhen Reach IT Co., Ltd. for SD video signal (D1/CIF) coding and network transmission. It can be used together with the full range of Multimedia Record & Play Servers of Reach. -
Page 6: Product View
REACH ENC110 SD Encoder User Manual 1.3 Product View Fig.1 REACH ENC110 SD Encoder 1.4 Product Interface Fig.2 Interfaces of ENC110 1 Power Input 5 Line In 2 Composite Video in (BNC) 6 LAN 3 Line Out 7 COM (RS232) 4 MIC In (XLR) ... -
Page 7: Product Configuration
Windows system, click Start→run→command to open the command line window, and enter <ping 192.168.1.100> in the command line window, and then click Enter key. If the following message appears, it indicates that the encoder has been normally started. Copyright© Shenzhen Reach IT Co., Ltd. 7 / 12 ... -
Page 8: Logging On Encoder Configuration Interface
Click “log on” button to enter the encoder management configuration page, as shown in the following figure: Copyright© Shenzhen Reach IT Co., Ltd. 8 / 12 ... -
Page 9: System Setting
The system supports simplified Chinese interface and English interface. To set the system language, you need to select the corresponding language and then click “save”. The system will exit the log-on interface, and you need to log on the system again. Copyright© Shenzhen Reach IT Co., Ltd. 9 / 12 ... -
Page 10: Change Password
Note: The upgrade takes about 3 minutes. Do not perform any other operation during this period. When the upgrade process is finished, the system will restart automatically. The system upgrade is completed after restart. 2.6.4 Change encoder IP address Copyright© Shenzhen Reach IT Co., Ltd. 10 / 12 ... -
Page 11: Parameter Setting
They can adjust the audio code rate to the appropriate range according to the actual needs. Copyright© Shenzhen Reach IT Co., Ltd. 11 / 12 ... -
Page 12: Caption Setting
The remote control of the camera can be realized through the SD encoder. Before using the PTZ control function of the encoder, please check the control protocol of your camera. The SD encoder currently supports VISCA, PELCO-D and PELCO-P protocols. Copyright© Shenzhen Reach IT Co., Ltd. 12 / 12 ...