Replacing Dummy Covers; Removing A Dummy Cover - Fujitsu PRIMERGY TX100 S2 Service Supplement Manual

Ê Insert each accessible drive into its installation bay and slide back until it is
flush with the front bezel (1).
Ê Secure each accessible drive to the drive cage with four screws
(M3 x 4.5 mm) (2).
Ê Connect data and power cables to each drive.
Ê Close the side cover as described in section
reconnect the AC power cord.
4.1.6

Replacing dummy covers

4.1.6.1

Removing a dummy cover

The following replacement routines require removing dummy covers:
– Replacing the front panel cable
– Replacing the front USB module
Ê Shut down the server and disconnect the AC power cord from the system.
Ê Remove the side cover as described in section
Ê Open the HDD cage as described in section
TX100 S2
Service Supplement
Replacement routines
4.1.1.2 on page 24
4.1.1.1 on page
4.1.2.1 on page 25.
and
23.
41